Heating And Air Conditioning Irving TX
With 24-hour emergency services and a 100% customer satisfaction guarantee, it’s easy to tell that AC Pros has your convenience in mind for heating and cooling in Irving, TX.
See our reviews below! You’ll learn why people rely on our friendly, experienced team to solve their home comfort issues in Irving, TX.
Local Reviews
for Irving, TX
Powered by Nearby NowOur Reviews by City
Longtime client
Jeannie - Irving, TX
John was great!
Thomas - Irving, TX
Fast, informative and personable. John did a great, quick assessment and told me everything we needed to hear during our option period on a new home.
Great service!
Richard - Irving, TX
Unknown issue
Jeannie - Irving, TX
Always great service
Jeannie - Irving, TX
Always satisfied
Jeannie - Irving, TX
Wonderful
Jeannie - Irving, TX
Always exceptional
Jeannie - Irving, TX
Joel S.
Upon arrival I spoke with Jeannie about what was going on with her master bedroom air conditioner. She stated that it wasn't really a humidity issue because her and her husband woke up hot one night. I verified that the refrigerant charge is good. Condenser coil was a little bit dirty. System has a perfect 20° temperature split she did show me pictures about the thermostat being in the scheduling program and the temperature would bounce around. I change the internal programs on the over Cooling limit. I added 1° today. That means when the thermostat is actually satisfied it will go one more degree. We can change this at any time. Upstairs thermostat would not hook up to the Wi-Fi in the home. I installed a train 850 and the internet hooked up immediately. We will order a new 1050 thermostat and return and install it when it comes in. Advise Jeannie to give the master bedroom about a week to see if it improves.
Jeff S.
Completed diagnostic, circuit# 1 compressor was out on internal overload due hi head pressure, expansion valve is faulty with restriction. Recommended replacing TXV or whole system - txv isn't in stock anywhere and not available to order P#HFES8HCA (found on Trane and Johnstone website) Circuit #2 which is compressor/ evaporator coil was low on refrigerant Added 4 pounds of R22 which has small leak in evaporator coil.
Joel S.
AC performance tuneup x 2 RTU. Inspect blowers, evaporators. Both units are brand new. Filter sizes are 4-16x25x2 Other unit is 4-20x25x2. Drains are clear and flowing. Pressures are good. Filters are good at this time. Both thermostats are in a bad location. Both are directly in the path of supply air flow. This will make the system short cycle and make the rest of the space feel warmer. Leaving a quote to relocate them. Otherwise systems are cooling properly at this time.
Jeff S.
Completed maintenance check drains are clear, refrigerant levels are good. All electrical components and contactors are in good shape. Also recommended replacing whole system because efficiency has drop over the years, life expectancy is 12 to 15years. Homeowner Will consider replacement in the fall and renew contract.
Joel S.
AC performance tuneup times two systems. Inspect blowers, evaporators and ductwork. Verified primary drains are clear at this time. Check thermostats for proper operations. Refrigerant levels are good at this time. Fasteners and contactors are good. Washed condenser coil‘s. System is operating at manufacture specs at this time.
Joel S.
Nothing is wrong with the thermostat. When I arrived the indoor temperature was 78°. And as I stood by the thermostat and saw vendors and employees opening up the south door the temperature started to rise quickly. The thermostat needs to be relocated. Construction is about to happen. We can relocate it then
Jeff S.
Adjusted fan speed to remove more humidity in Masterbedroom. Checked refrigerant levels which was good. Its 67 degrees in room right now. Did not find any problems at this time.
Jeff S.
Completed diagnosis, found breaker tripped inside of main panel, will Not reset. Its a three phase breaker, customer will call a electrician.
Jeff S.
System was not cooling, due to a dirty media. Changed out provided by homeowner.
John h A.
One system two zone , check system operation indoor unit amp draw is 1.6 drain is clean, out door unit dirty needs cleaning pressure is good compressor fan motor good 1.0 amps compressor 9.0 amps
Joel S.
Thermostat head error code 155.04 upon arrival. That stated that the EEV was not opening properly. I ran the valve through the system test and it passed. Possibly could’ve been stuck slightly. I’ll turn system down and checked charge. System has a 9° sub cool. System is operating properly at this time.
Jeff S.
Performed maintenance on all 5 systems: Replaced all media filters, compressor/fan and blower motors are good. Drains are clear, temperature splits were in range. Condenser coils are clean. Refrigerant levels and sub cooling is fine. No problems found at this time. Also homeowner renewed Gold membership for 4 systems.
Joel S.
Upon arrival I cleared a message about changing the filter. Went to attic to see if the furnace had an issue firing up. Furnace is good systems are operating properly at this time.
Joel S.
Hard lock out on outdoor unit. Thermostat showed low pressure on the system which caused a hard lockout. Around the system and heating, again and cooling, and again and heating. Each time pressures were perfect. Could be a glitch with the thermostat. I advised Christina that if it happens again to just to try to cycle power to the unit to reset everything.
Francisco S.
Calibrated thermostat temperature was several degrees out pics on service titan of after calibration no charge no signs of thermostat tamper with
Joel S.
System had an error code 184.02 and 185.07. System was overcharged. Dome temperature reached exceeded amounts of retries. Recovered refrigerant. System operating at manufacture specs at this time.
Jeff S.
Performed maintenance inspection on heat. Discovered that heat exchanger is showing a lot of wear. Recommend replacing the furnace. Attic insulation and ductwork is in good condition. Test for gas and carbon monoxide leaks, nothing was detected. Also emergency drain pan is rusted out, Recommended replacement. Declined repairs at this time.
Jeff S.
Heat pump system was in hard lock out, check sub cooling 10 degrees, expansion valve seems to be working good. I think pressure trandsducer is faulty, sending low pressure signal back to inverter, causing system to go into hard lock out. Parts needed low pressure transducer for heat pump XV20.
Joel S.
Post install walk-through on recently installed equipment. Reinstalled 824 thermostat client paid for. I noticed that the air conditioner on the 15 ton was not running at the condenser.Found that there was no signal making it to the outdoor unit. I ran new control wire but that did not fix the problem. Replaced 824 thermostat and system came on and operating properly.
Joel S.
Make 15 ton unit ready to work. Install 2 824
Joel S.
Heat performance tuneup x 1 system. Filter is needing to be changed soon. Inspect blower, evaporator, and ductwork. Test all safety features. High limits and rollouts. Tighten all wire connections. Clean flame sensor and inducer ports. No CO2 detected or gas leaks. Test temperature rise. 37* Test Tstat for proper operation. System operating at MFG specs at this time.
Jeff S.
Performed heat maintenance inspection, checked all heating components, replaced media filters. Everything is working properly.
Jeff S.
Performed heat maintenance inspection, replaced two aprilare media filters, 210 and 410. Recommended adding surge protectors and uv lights to system. Heaters are working properly, no problems found with them. Total cost of Reme Halo $995.00
Francisco S.
Found system low on refrigerant r22 recommended replacing no charge per Russ
Jeff S.
Water leak in hallway: surveyed equipment area, found that it's not an A/C problem. Homeowner may have to call a plumber out.
